Waiting chair installation and maintenance methods

When we wait for the train at the station, we will see rows of waiting chairs, which provide us with a place to sit. From the appearance, we also know that the installation of such waiting chairs should be relatively simple. Interested friends can come to see how to install waiting chairs and maintenance methods.

Here is the content:

• Stainless steel waiting chair maintenance methods

• Waiting for the installation of the chair steps

Stainless steel waiting chair maintenance methods

1. The surface of waiting room chairs contains a binder composition of the stain, you can use alcohol or organic solvent scrubbing.

2. The surface has trademarks, you can use warm water with a weak detergent to wash.

3. If the surface has oil, grease, or lubricant pollution, use a soft cloth to wipe clean, and then use ammonia solution, neutral detergent, or special detergent to clean.

4. The surface of waiting room chairs has bleach and various acids attached, immediately rinse with water, and then use neutral carbonic acid soda solution, ammonia solution to dip wash or use warm water, and neutral detergent to wash.

5. There is dust, or easy to remove the dirt, you can use weak detergent, soap, and warm water to wash.

6. In daily use, you should often wipe the dust and stains to keep the waiting chair clean. Clean to try to use a soft cotton cloth that is not easy to remove lint, and must confirm that it is clean without foreign objects of soft cotton cloth, such as the use of too hard, or clumsy rags or with cotton cloth wipe test, will wear waiting for chair lacquer, fall short of luster.

7. Do not use hot water, alkaline water, or disinfectant water, such as washing outdoor furniture, which will ruin the exterior of the waiting chair paint. If the furniture is protected by waxing, in the purchase of wax, it is best to choose a high concentration of solid wax, it can fill the small defects on the outdoor waiting area chairs. In addition, spray wax is also a good choice. But don't use both together, or it will make the waiting chair appearance a trance, no longer shiny.

Waiting for the installation of the chair steps

1. The seat back version is neatly arranged on top of the linen or cardboard.

2. In the seat plate above the corresponding place, install the link with the beam, fixed with screws.

3. Adjust the seat plate position again, the screw holes above the crossbeam to correspond with the holes of the links, and fixed with screws.

4. Install the station foot, the station foot, and the station foot fasteners fastened to the crossbeam and then fixed with screws.

5. Twist on the foot pad (pad foot has large, small 2 kinds of options)

6. Fixed all the screws, and the row of waiting area chairs square, the installation is complete.

   
   

Production of waiting chairs that meet the standards is the responsibility of each manufacturer to ensure the healthy development of the market. Hongji has conducted several tests on the product before leaving the factory, and the quality pass rate is guaranteed.